These ports shall allow the transmission of IR signals (using an IR emitter) or unidirectional RS-232 communications for control of AV system components Device shall have three configurable IR/Serial ports on captive screw connectors located on the back of the controller.Device shall have six normally open low voltage relays on captive screw connectors that can be configured to control lighting, screen control or other device functions.Device shall support up to two secondary control panels for additional points of control and shall be wired into the captive screw connectors located on the back of the panel.Device shall support up to four addressable button modules that allow for expandability and shall be wired into the captive screw connectors located on the back of the panel.Device shall support one configurable digital I/O on shared 9 pin D connector located on the back of the controller that can be used to interface with devices such as sensors, switches, LEDs and relays.Device shall support one digital input on captive screw connector located on the back of the controller that can be used to interface with devices such as sensors, switches, and relays.Device shall have a configurable bidirectional RS-232 or IR port on captive screw connectors located on the back of the panel for universal display control.Device shall feature a 2.5mm TRS socket on the face plate that allows for device configuration and setup.IR receiver shall be located on the face plate of the controller Supports the creation of IR drivers by capturing IR commands from handheld remotes.When configured, these LEDs shall provide visual feedback to reflect the relative of the audio level of the AV system Device shall feature 5 LEDs, four green and one red arranged vertically located adjacent to the rotary encoder.Device shall provide a rotary encoder knob located in the bottom left of the panel that can be configured to control the audio level of an AV system.Buttons shall feature removable button caps allowing them to be custom labeled for easy identification.Buttons shall illuminate red, green, or amber, depending on function, for ease of use in low-light environments. Device shall have a total of 11 fully configurable tri-colored LED lit buttons, six dedicated for input selection, three dedicated for room control and the remaining two dedicated for power.Configuration-based, mountable, Ethernet enabled controller with button panel interface.Provide an Ethernet enabled, 3-gang button panel controller for the purpose of remotely controlling, monitoring and troubleshooting connected AV equipment and AV systems.
0 Comments
Leave a Reply. |